How To Lift A Car With A Floor Jack

Jacking up your vehicle and implementing jack stands.

How to lift a car with a floor jack. Some require only three pumps to lift or get ready to work. If the floor jack extension saddle starts compressing the load check the direction the jack is lifting the load. Park on a solid surface.

Place the floor jack so it contacts the rear lift point and raises the vehicle. Lower the vehicle down onto jack stand or back to the ground easy by slowly turning the jack handle and controlling the rate of descent of the car. If you start with the rear the front end may be tilted so far that you can t roll a jack under it.

How to jack up a car diy with scotty kilmer. When you park the vehicle make sure you use the. How to properly use a jack floor jacks and jack stands to lift up your car to work on it.

To raise one of the rear wheels position the jack just in front of the wheel. For most cars the recommended front lift point is the engine cradle cross member photo 1. It should be vertical and without a lot of horizontal loading.

Lift and support the front of the car first. Pump the handle a couple of times to lift the vehicle. This video is about lifting half of the car with floor jack instead of lifting each side.

This will raise the jack up to the jack point and begin lifting the vehicle. Place the floor jack under the jacking point to lift the vehicle position the floor jack under the jacking point. Say clear loudly as a safety double check in alerting others that you are now going to lower the vehicle.